GB
Sound module USM-RC-3
11.10.2021
BEIER-Electronic
23
Connection of sound module in Digital mode with UFR ESC
Connection to UFR-1230 speed controller
The sound moduel pin header X2/1 is connected to the pin strip X4/1 (bottom) of the
speed controller with one of the supplied servo patch cables. With this connection
the sound module receives all information about speed and light settings.
At the sound module the servo patch cable must be plugged with the brown cable
pointing to the board edge and the orange cable to the board center.
Connection of proportional inputs
Up to 7 proportional outputs of an RC receiver can be attached to connectors X2/2 -
X2/8. Just use the two supplied servo patch cables for the connection. If more than
two proportional channels should be connected, further servo patch cables are
required. These can be ordered from us in our online shop in two lengths (15 cm and
30 cm).
A label on the cover of the sound module indicates the locations of the eight
channels. Channels # 1 and # 2 are duplicated so that the proportional signal can be
passed on to the speed controller.
Please attach the servo patch cables to the sound module with the brown wire face
the board edge and the orange wire to the board middle!
Following functions can be triggered with the 8 proportional channels on the sound
module:
Channel
Assignment
#1
Connection for UFR speed controller
#2
Steering / Free assignment of functions
#3
Free assignment of functions / Nautic 1 / EKMFA / Control Pad 1
#4
Free assignment of functions / Nautic 2 / Control Pad 2
#5
Free assignment of functions
#6
Free assignment of functions / Bluetooth module BTC-1
#7
Free assignment of functions
#8
Free assignment of functions / Sum signal
#9 - #16
Free assignment of functions (can only be used with a sum signal)
The channel numbers of the sound module have nothing to do with the channel
numbers of your receiver. So you do not have to connect channel #1 of the receiver
with channel #1 of the sound module.
Connection of switching inputs
You can use the switching-inputs at the terminals X1/3 – X1/6 to trigger four different
functions (see page
Fehler! Textmarke nicht definiert.
).
