Operating Instructions
HBP530A-CNC
BA85308
Status 46/04
Rev 07.02.11
Page 8
1.6 Location of the Operating Instructions
The Operating Instructions should be kept on hand in the vicinity of the machine at all
times.
Important!
Damage caused as a result of non-adherence to the Operating Instructions
is not covered under warranty.
1.7 Emergency Stop
The machine can be shut down as follows:
•
corresponding operation of the control unit
•
by activating the emergency stop,
•
opening the protection hoods
•
opening the safety guards (if existing).
Danger!
Protective plates and covers prevent access to the machine. They are
designed to protect operators and other persons and must not be removed
or modified.
1.8 Common safety regulations
•
During cleaning-, maintenance work and repairing switch off the main switch and
support the saw frame!
•
Never grip during the sawing process in the sawing- or clamping zone! Attention the
machine lags!
•
The operator is responsible that during the working process no person is in the danger
zone (supply- or dispatch-table roller, measure car, angle adjustment etc.)!
•
During the dead man working process the necessary regulations are to observe!
•
If there are disturbance or to do manual doings, during the automatic process always
switch over into the manual process!
•
Repairing at the electric device only from the electric expert.
•
The machine is always to switch off before repairing are done at the electric device! The
machine is to protect against re-switch on!
•
If the main switch is switched off however some parts of the machine are alive, for
example:
-
Hydraulic oil- or coolant-heatings
-
Switchgear cabinet plug socket
-
Switchgear cabinet lighting set
