EUROLIVE S1020/S1220/S1220F/S1520/S1530/S1800S
Wiring
5
Power amp rating
3.
The power rating of your amplifier should be roughly twice the
continuous speaker load capacity. A speaker rated at 200 Watts
continuous power can easily be powered by an amp rated at
400 Watts output power. An optimal addition to your speaker
system would be the BEHRINGER EUROPOWER amplifiers.
Attention!
When several loudspeakers are wired in parallel the
+
overall impedance Z
total
to be handled by the power amp
can be calculated, as shown below, from the individual
impedance values of the connected speakers:
Your amplifier may be damaged if the actual impedance
drops below the minimum impedance specified for your
amplifier. Please make sure that the calculated total
impedance Z
total
is not smaller than specified.
Wiring
4.
Full-range stereo operation
4.1
This application is for the full-range loudspeakers
S1020
,
S1220
,
S1220F
,
S1520
and
S1530
.
In the following example, the main output signal of a mixing console
is connected to a power amplifier. Both the outputs and inputs
are stereo. A full-range loudspeaker is connected to each amp
output, and these loudspeakers reproduce the entire frequency
range (full range).
Full-range stereo operation
Fig. 4.1:
Two-way stereo operation with subwoofers
4.2
This application is for the subwoofer
S1800S
in combination
with the full-range speakers
S1020
,
S1220
,
S1520
and
S1530
.
Using an external (active) crossover, the main output signal of a
mixing console is divided into two signals. One signal covers the
lower frequency range and the other signal covers the mid-to-
high-frequency range. The recommended crossover frequency
is 200 Hz. Then, the mid-high frequency signal is connected to a
stereo power amplifier. A loudspeaker is connected to each of the
amplifers outputs. The low-frequency signal is connected to an
additional power amplifier, which powers the subwoofers.
Two-way stereo operation with subwoofers
Fig. 4.2:
