– 12 –
behrotest
®
K8 / K12 / K20 / K16 / K24 / K40
0591
11
Configuring the K8 / K12 / K20 / K16 /
K24 / K40 to meet your needs
You can, in fact, use your K8 / K12 / K20 / K16 / K24 /
K40 for analyses right now. You should, however, take a
couple of minutes to perform one or two settings.
These settings can, of course, also be made or modified
at a later time.
This screen will appear when the unit is switched on:
Prog 01/01
==>>
022
°C
Turn the operating button until the ==>> menu item
is indicated and then press the button. The following
menu will appear:
GERAET
PROGRAMM
<<== zurück
01
Select the
Geraet (Device)
menu item.
You will then move to a menu consisting of two
pages.
Select the required entry by turning the operating but-
ton if you wish to change a setting. Press the button to
select the entry and set the required value by turning the
button. Store the value by pressing the operating button
again.
The Start menu
1 If a program has been started, or the unit is preheat-
ing, the target temperature is displayed here.
If no program is running, but a starting time has been
selected, the starting time is displayed here.
This box is otherwise blank.
2 The temperature currently measured by the tempera-
ture sensor is always displayed here.
3
„Start”
menu item: The temperature program most
recently selected starts if this menu item is selected.
What program this is is1 indicated at bottom left.
4
„Preheat ON/OFF“
menu item: the K8 / K12 /
K20 will preheat to the starting temperature for the
temperature program selected if this menu item is
selected. The menu item will then change to
„OFF“
.
Select
„OFF“
in order to switch the heating function
off again.
5 The program currently selected, and the program
step reached, are indicated here.
6
„Continue“
menu item: select this menu item to
access other possible settings. You can
-
select another program
-
write a new program
-
configure the unit to your needs
Prog 01/01
14:05
==>>
022
°C
3
1
6
5
4
2