3
Programming Your Brazen
The Brazen comes with default settings that are appropriate for brewing. Pre-Soak 15 seconds, Brew
Temperature 200° F (90° C), and Altitude of 0 Ft. You can exit the programming modes at any point by
hitting the “On/Off” button.
Videos of the following procedures can be found online at: www.behmor.com
1.
Set Auto Start Time:
Press “Mode.” A clock time will appear on the LED screen with
the hour digit blinking (Figure 1).
a.
Set Hour- press up/down arrows until hour is correct. Once hour is ready press “Set”.
Note: the time cycle is 12 hours and AM/PM changes as you pass 12:00.
b.
Set Minutes- press up/down arrows until minutes are correct. Once minutes are
correct press “Mode” to continue to setting the Pre-Soak Time.
2.
Set Pre-Soak Time
: A clock time will appear on the LED screen with the minute digit
blinking (Figure 2). The adjustable time range is 15 seconds to 4 minutes.
a.
Set Minutes - press up/down arrows to desired minute setting. Once done press “Set”.
b.
Set Seconds - press up/down arrows to desired seconds setting. Once done press
“Mode” to continue to setting the Brewing Temperature.
3.
Set Brew Temperature
: The current brewing temperature will appear on the LED screen
(Figure 3 and 4). Press the “Set” button to switch between °F and °C.
a.
The adjustable range is 190°F-210°F (88°C-99°C).
b.
Press up/down arrows until desired temperature is shown, then press “Mode” to
continue to setting the Current Time.
4.
Set Current Time
: A clock time will appear on the LED screen (Figure 5).
a.
Set Hour- press up/down arrows until hour is correct. Once hour is ready press “Set”.
Note: the time cycle is 12 hours and AM/PM changes as you pass 12:00.
b.
Set Minutes- press up/down arrows until minutes are correct. Once minutes are
correct, press “Mode” to continue to the System Calibration.
5.
System Calibration
: The word “calibrate” above four digit places will appear on the
LED screen (Figure 6).
a.
Set elevation in feet: press up/down arrows until the approximate elevation for your
location. Determine your elevation by viewing the table below or visiting a weather
website such as
http://wunderground.com
. The Brazen is programmed to allow the
user to set their altitude to the nearest 250 feet.
b.
Fill the reservoir with water (Filtered or bottled is best) to the “Calibration fill line”.
c.
Make sure that you do not put the reservoir lid back on for this process. Please use
caution during this process as the water will be heated to boiling without the reservoir
lid in place. DO NOT move the unit during this process.
d.
Press “Start.”
e.
The heaters will turn on and bring the water to a boil for 15 to 30 seconds.
f.
A beep indicates the system calibration is complete.
g.
Fill the water in reservoir up to the 8 cup line for brewing or press “Start” and let a full cycle run to rinse the
machine. Be sure to have the carafe and filter basket are in place during this process.
