7B
REV. C
B-5
Table 1-1
CILL SOFTWARE COMMANDS (cont)
IST <cr><lf>
Instructs AC Power Supply to perform internal self test. The STA
command transmits the message. The AC Power Supply responds
with one of the following:
Pass
<sp><cr><lf>
Fail
F /07ACS /0(DEV): BIT TEST FAILURE
-PROM CHECKSUM FAULT
-RAM FAULT
-AC SUPPLY HARD FAULT
<cr><lf>
CILL COMMANDS
EXPLANATION
STA <cr><lf>
Status. Prepares AC Power Supply for a response transmission.
Clears error condition if one exists. The following response
messages and conditions exclude confidence and internal self
<sp><cr><lf>
Device error messages
F /07ACS /0(DEV):BIT TEST FAILURE
<description consisting of up to 6 /0 characters>< cr><lf>
TMA error messages All begin with:
F /07ACS /0 (MOD):
This message is followed by one explanatory message from the
following text:
ILLEGAL NOUN
AC Power Supply does not recognize illegal noun.
ILLEGAL NOUN MODIFIER
AC Power Supply does not recognize illegal noun modifier.
ILLEGAL OPCODE
AC Power Supply does not recognize illegal opcode.
ILLEGAL VALUE
Entered value lies outside upper and lower limits.
NO SETUP
Close command received but setup not programmed.
Example: F /07ACS /0 /0(MOD): NO SETUP <cr><lf>
Summary of Contents for BL20000 Series
