BEHABELT MultiTC, Instruction Manual

Page: 19 / 20

19
Cut off both ends of the profile to be connected�
Fix belt ends in appropriate guide clamp at a dis-
tance of approx� 5 mm�
Once the welding paddle has reached the ideal
welding temperature (see rear side), insert wel-
ding paddle in the gap and press both belt ends
slightly onto the paddle� Press the belt ends at
least 30-90 sec� together (depending on the ma-
terial cross section)�
If you have carried out an accurate welding, a
belt boss of approx� 3 to 4 mm appears between
the belt ends and the welding paddle free of blow
holes�
Please make sure that the total surface of the belt
ends forms a boss during the heating-up time�
Release the pressure on the clamp an remove the
hot paddle� Quickly press the belt ends together
and close the set screw on the belt clamp�
Welding process is finished�