4C
A.
GENERAL INSTRUCTIONS
The following points are important for safety as well as for the smooth
installation and performance of the unit.
• Unpack carefully and be sure that no damage has occurred during shipping.
• It is very important to ground the yellow/green conductor in order to meet
regulations for safety.
• Do not connect the device to any dimmer pack
or power pack.
• The electrical work that is necessary for installation must do by qualified
personnel.
• Be sure to locate the unit in a place with adequate ventilation at least 15 cm from
the walls. Be sure that no ventilation slots are blocked.
• Be careful that no liquids or other objects can enter the unit. If this ever happens,
disconnect the main power immediately.
• In the event of serious operating problems, turn off the unit immediately. Never try
to repair the unit yourself. Repairs carried out by non-qualified personnel can lead
to serious damage or malfunction. Please contact your dealer about authorized
technical assistance. Always use genuine spare parts.
•
Occasional breaks are necessary to prevent breakdowns. This unit is not designed
to be used non-stop.
• Always remember to unplug the unit from the mains power before any service is
done.
• Please recycle the packaging.
• Start the address
1. Select the channels of DMX controller
2. Dip switches
Dip #1 #2 #3 #4 #5 #6 #7 #8 #9
Value
1 2 4 8 16 32 64
128
256
• Examples:
Channel 1 : dip / on : #1 (=1)
Channel 4 : dip / on : #3 (=4)
Channel 7 : dip / on : #1, #2, #3 (1+2+3=7)
Channel 10 : dip / on : #2, #4 (2+8=10)
(2). Preprogram functions
•The unit can be linked together as master/slave in 2 or 4 channels and run by built
in preprogrammed chase sequences by sound activation. When sound stops, all
the lights will shut down (blackout) immediately and then the bulb will turn off 15
seconds later. Please refer to the unit dipswitch-setting table for how to set the
dipswitches to achieve master/slave linking.
•In master/slave mode, the dipswitch 10 must be on of the master unit.
2-Channels dip switches setting
Master
Slave 1
4-Channels dip switches setting
Master
Slave 1
Slave 2
Slave 3
