M E X
P O W E R & I N T R O
P O W E R I N G T H E
M O D U L E
U S E R M A N U A L
T H A N K S F O R P U R C H A S I N G A M O D U L E F R O M B E F A C O !
B E F O R E Y O U P L U G T H I S M O D U L E I N . . .
1.
Disconnect your cabinet from the mains.
2.
Triple check the power cord polarity.
Connect the cable from
EXPANSION_PORT (Muxlicer) to TO_MUX (MEX). Check the picture below to
align the connector according to the polarity (marked on the PCB).
3. If you plug the module backwards you might burn it out and
unfortunately this is not covered by the warranty.
4. If you have any questions about this product feel free to contact us:
.1
I N T R O D U C T I O N
W H AT I S M E X ?
MEX is an expansion module for Muxlicer that adds an extra 8-step Gate sequencer to Muxlicer
.
The module is powered directly from the Muxlicer’s expansion port located at the back of the module (see connection diagram
above).
MEX counts with a very straight forward interface based on ten elements: eight three position switches (to
select the mode for each step), a Gate Input and a main Out for the Gate signals.
Several MEX can be connected
in series via the THRU connector
at the back of the module.
To connect it, use the provided
cable keeping in mind that the red
lines must match with the white
lines on the silkscreen.
Gate In
Not Gates
All Gates
