2.6. Connection
The speaker automatically connects to the last connected device when it is turned on. If the device is not found,
the speaker will connect to a previous device in the paired list.
In case the connection is not made automatically, it is possible to reconnect manually either from the speaker by
pressing the MFB or from the mobile device (refer to the phone user manual). It is also possible to disconnect
the speaker either manually or by moving out of range. When losing the connection/link, the speaker will
automatically power off after 15 minutes.
2.7. Multipoint
The Multipoint function allows a simultaneous connection to 2 mobile phones. In default setting of the
speaker’s Multipoint function is disabled.
- To enable Multipoint function: in standby mode, press and hold “V+” button for 3 seconds until a beep is
heard. If 2 mobile phones are already paired to the speaker, they will connect automatically when powering on
the speaker.
- To disable Multipoint function: in standby mode, press and hold “V-” button for 3 seconds until a beep is
heard. The speaker will turn off multipoint function and power off automatically. When powering on again, the
speaker will only connect to the last connected Bluetooth device.
2.8. Function Matrix
Feature
Key
Conditions
Operation
Power On
Powered off
Long press 3 seconds
Power Off
Powered on
Long press 3 seconds
Pairing
Powered off
Long press 6 seconds
Answer a call
Incoming Call
Short press
Hang up a call
Talking
Short press
Reject incoming call
Incoming Call
Long press 3 seconds
Voice dial / Cancel
Voice Dial
Standby Mode
Short press
Last number redial
Standby Mode
Short press twice
Switch active calls*
2 Calls in process
Short press twice
Hang up call 1 and
answer call 2*
2 Calls in process
Short press
Reject call 2*
2 Calls in process
Long press 3 seconds
Switch audio to/from
phone
+ & -
In call
Simultaneous press
Mute microphone
-
In call
Long press 3 seconds
Un-mute microphone
+
Long press 3 seconds
Volume up
+
In call
Short press
Volume down
-
In call
Short press
* 3-way calling not supported if Multipoint function enabled
2.9. Restore to Default Setting
To reset the speaker to the original settings and remove all the previous pairing and connections, just press and
hold both “V+” and “V-” buttons simultaneously for 10 seconds until the blue and red LED lights flash 5 times.
Contacts:
JSC „Ainera“
Tel: +370 37 209747
E-mail:
www.ainera.lt