10
GAS BOTTLE SAFETY
GAS BOTTLE SAFETY
INSTALLATION WARNINGS
Gas inlet pipe
Fibre washer
Test point adaptor
- ensure arrow is in
the right direction
Supply hose or pipework
with 1/2’ tapered thread
- sealed with thread
seal tape or compound
suitable for gas
connection
Connecting to a remote supply of LPG
The components required to make this type of connection
are available as an accessory and can be purchased either
on the Electrolux spare parts website or by contacting the
Electrolux Customer Service Centre� Refer to Accessories
section on page 17�
Never connect the barbecue to an unregulated LPG supply�
Ensure that the supply pressure at the inlet of the barbecue
is 2�75kPa�
Electrolux strongly recommends installation of a manual
shut-off valve, or hose assembly with a certified quick
connect that is accessible with the appliance installed, so
that the appliance may be isolated from gas in the event of
an emergency or for servicing�
The components required are
• Brass test point adapter
• Sealing washer
To assemble the connection:
• Connect the brass test point adapter to the barbecue
gas inlet with the arrow on the adapter oriented
according to direction of gas flow, with the sealing
washer in place to seal the connection�
• The inlet to the adapter has a standard internal ½”
pipe thread and can connect to any standard external
½” tapered threaded connection� This connection is
sealed with any thread tape or sealing compound that
is suitable for gas connections� Connect the fixed LPG
pipework to the inlet of the test point adapter by any
suitable means in accordance with requirements of
AS 5601�
• Leak test all connections in the assembly as described
under LEAK TEST PROCEDURE�
WARNING
WARNING
• This appliance shall only be used in an above ground,
open air situation with natural ventilation, without
stagnant areas, where gas leakage and products of
combustion are rapidly dispersed by wind or natural
convection� This barbecue has been designed for
outdoor use only� Refer to diagrams below�
• Never install this barbecue inside any building,
garage, shed or breezeway or inside a boat, caravan or
recreational vehicle� This is to prevent the possibility of
fire or carbon monoxide poisoning or asphyxiation�
• Any enclosure in which this appliance is installed shall
comply with one of the following:
- An enclosure with walls on all sides, but at least
one permanent opening at the ground level and no
overhead covering�
- Within a partial enclosure that includes an overhead
cover and no more than 2 walls�
- Within a partial enclosure that includes an overhead
cover and more than 2 walls, the following shall apply:
- At least 25% of the total wall area is completely open
and at least 30% of the remaining wall area is open
and unrestricted�
• In the case of balconies, at least 20% of the total of the
side, back and front wall areas shall be and remain open
and unrestricted�
Outdoor area
example 1
Outdoor area
example 2
Both ends
open
Outdoor area
example 3
Open side at least 25%
of total wall area
30% or more in total of the
remaining wall area is open
and unrestricted
Outdoor area
example 4
Outdoor area
example 5
Open side at least 25%
of total wall area
30% or more in total of the
remaining wall area is open
and unrestricted
