3. SETTING UP AIRFRAME
Now attach the arms and the ring plates. For this assembly use 2 ring plates, 4 arms and take out 12 M3X16 screws
(Bag # 2), 4 M3X20 (Bag # 3) and 12 M3 nuts. Place 4 screws M3X20 outermost holes.
Arms 1 and 3. This will be used for the landing gear mount. Place 4 screws M3X20 from the bottom up. These will be
used to fix the plastic spacers. Take the center plates and separate them so you can position the arms. With all four
arms in place adjust a single screw on each side until the arms are held in place. The arms should be secure in the
frame but not so tight as to be bending the center plates.
White circles for M3X20 and yellow circles M3X16 (next page).
Before fastening completely the nuts inset the aluminum spacer (Bag #4) between the arms, as shown in the photos.
The screws M3X20 will be used to fix the landing gear and define the front and rear.
