BEDU S Series, Operating And Maintenance Manual, Page: 5 / 40

1. GENERAL INFORMATION
1.1 SUPPLY CONDITIONS
According to Customer’s requirements, the pump can be provided both as bare shaft pump
and as pump unit. By pump unit it is meant the pump aligned with the engine, including driv-
ing elements, baseplate and any auxiliary machinery. The pumping group is supplied with
safety coupling guard.
1.2 MANUFACTURER
The pump Manufacturer is
Bedu Pompen B.V.
. You can apply for assistance by send-
ing a request to the following address:
Bedu Pompen B.V.
P v M Gelderland Rood 10
6666 LT HETEREN, The Netherlands
Tel: +31 (0)88 4802 900 ­ Fax: +31 (0)88 4802 901
1.3 USER MANUAL CONTENT
This user manual provides all the necessary information to ensure a safe and correct use of
the machine. It was written
– when applicable – according to point 5.5 of Standard EN 292
part 2-1992 - Machinery Safety; according to point 7 of Standard UNI EN 809-2000 Pumps
and Pump Units for Liquids - Common Safety Requirements - and according to point 1.7.4 of
Directive 98/37/EC 1998 (ex 89/392 EC). In this manual it is constantly referred to safety in-
structions. Such instructions are identified by the following symbols:
It represents the safety instructions contained in this manual,
whose non-observance may compromise safety.
It is shown when electrical safety is essential to worker protection.
It indicates the safety instructions which should be taken into ac-
count for the safe operation of either the pump, the pump unit or the
pump or pump unit protection.
www.bedu.nl