Bedford WS-1200mm, Assembly Manual

Page: 8 / 8

9.2.4.11 Revision 1 TP05-159

Screw 1 is used for adjustment

Screw 2 is used to secure hinge to hinge plate
The following instructions explain hinge
adjustment if gap between the doors is too wide:
1. Start from the top hinge
2. Loosen screw 2 by turning screw in an anti-
clockwise direction.
3. Now, turn screw 1 in a clockwise direction
(the amount to turn this screw is determined
by the width of the gap between the doors).
4. Tighten screw 2 by turning in a clockwise
direction
5. Repeat this step for all the hinges.
6. Check gap between doors (should be
approximate 2mm), if not repeat steps 1 to 5.
It is strongly recommended to secure the unit to the wall, otherwise, it may tip forward when opened empty.