Weed brush
–
Edge cutter
OBKS50-35
Version: 1
November ’19
Page 16 of 25
4.2.
Carry out brushing- and cutting work
•
At driveways or other obstacles in the cutting-lane the blade needs to be lifted
in time, to prevent damage to the pavement and machine
No.
What to do
Action
Result
1
Check the machinery
Check the following points:
Check the blade on cracks or damages
Check the speed of the brush-motor (50% of
the capacity (30 liter)) is usually enough for a
good result
Check whether the brush-motor runs without
excessive shaking and without abnormal
sounds.
Check the control of the width and height-
adjustment of the blade.
If a defect is identified in one of the above
points, this must first be remedied before it is
allowed to put the weed brush back into
operation.
2
Drive to the site
where the work will
take place.
Always switch off the weed brush if you are
not doing any brushing.
3
Switch on brush-
motor
Please refer to the detailed instructions in the
manual for the tool carrier.
It is important always to switch on and off at
a low revolution speed to prevent damage to
the machinery. The revolution speed can be
increased after switching on the brush-
engine.
Switching on and off
at a high speed of
revolutions will
result in system
overload.
4
Setup the blade in
desired position
The knife can be adjusted in width-position
and in height, make sure it is in desired
position. For detailed instruction, see manual
of tool carrier.
Watch for people or animals in near working
area.