EN
15
Electrical connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in
compliance with national regulations.
t
The power plug must be easily
accessible after installation.
t
Electrical safety of your appliance
shall be guaranteed only if the earth
system in your house complies with
standards.
t
The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
t
Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated
before it is repaired! There is the risk
of electric shock!
Disposing of the packaging
The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions stated by your
local authorities. Do not throw away
with regular house waste, throw away
on packaging pick up spots designated
by the local authorities.
The packing of your appliance is
produced from recyclable materials.
Disposing of your old
appliance
Dispose of your old appliance without
giving any harm to the environment.
t
You may consult your authorized
dealer or waste collection center of
your municipality about the disposal
of your appliance.
Before disposing of your appliance,
cut out the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.
Placing and Installation
A
If the entrance door of the room
where the appliance will be installed is
not wide enough for the appliance to
pass through, then carefully remove
the doors of your appliance and pass
it sideways through the door.
1.
Install your appliance to a place that
allows ease of use.
2.
Keep your appliance away from heat
sources, humid places and direct
sunlight.
3.
There must be appropriate air
ventilation around your appliance
in order to achieve an efficient
operation. If the appliance is to be
placed in a recess in the wall, there
must be at least 5 cm distance with
the ceiling and at least 5 cm with the
wall. Do not place your product on
the materials such as rug or carpet.
4.
Place your appliance on an even
floor surface to prevent jolts.