Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 382 / 498

A13914AF
10-18
System Status and Commands
Unload All
2
Select
7 Enable/Disable Modules
.
3
Select the box of the desired module with a
Disabled
status to enable a module (remove blue
indicator bar).
4
Select
OK
to enable the desired modules.
5
After Enable is requested, there is an eight-second delay before the system starts to prime.
NOTE
Do not press
RUN
during this eight-second delay. Samples would not be run (NOT ACCEPTED
error) because the system is priming.
Unload All
Introduction
Unload All is used when the instrument is in Standby . It removes all the sample racks, from the
sample carousel, to the offload track. It can be used:
•
When access to a sample is required, or
•
After a system error, if a rack is shown on the
Main
screen, but it is not physically on the
carousel.