Beckman Coulter Biomek NXP, Preinstallation Manual

Page: 37 / 52

B20063AC
3-7
Preparing Cytomat Devices
Setting Up Optical Tables
3
Figure 3.2 Assembled .6 m x .9 m Optical Table
2
Set the table(s) at a location with adequate electrical, air, vacuum, and system fluid resources
for the Biomek NX
P
instrument and Cytomat devices (see CHAPTER 1, Preparing the Site ,
CHAPTER 2, Preparing the Biomek NXP Instrument for Setup and the section titled Cytomat
Device Specifications ).
3
Tilt the shelf at an angle and maneuver it between the legs of a table. Set it down across the
table base.
4
Set the optical platform onto the table and align the edges.
5
To level the table, place a level across the optical platforms and adjust the feet by turning them
clockwise or counterclockwise as necessary.
1. Optical Platform
2. Table Shelf
3. White Plastic Feet (installed)