2-5
Preinstallation Requirements
INSTALLING THE BRAKE PIN AND STATOR PAD
1. Place the brake pin in the hole at the center of the stator (see
Figure 2-2). Make sure that the slot in the pin bottom straddles
the brake spring wire as shown in the figure.
2. Lightly touch the pin. It should bounce back freely to about 3 mm
(
1
/
8
in.) above the stator. If the pin is too high (approximately
6 mm above the stator), gently turn the pin so that it drops down
to straddle the spring wire.
3. Install the black ring-shaped stator pad in the channel of the stator.
Figure 2-2. Aligning the Brake Pin in the Stator. The slot on the end of the pin straddles the brake spring wire.
The broken line shows the wire direction (aligned with the screws). If the tip of the pin slot stands
on the wire instead of straddling it, the pin will be too high above the stator.
Brake Pin
Brake Pin Slot
Stator Screw
Stator Screw
Stator Pad
Stator
Brake
Spring Wire
WRONG