Beckhoff EJ3255, Documentation

Page: 36 / 60

Commissioning
EJ3255 36 Version: 1.1
6.2.1 Restore object
Index 1011 Restore default parameters
Index
(hex) Name Meaning Data type Flags Default
1011:0
Restore default parame-
ters [
}
58]
Restore default parameters UINT8 RO 0x01 (1
dec
)
1011:01 SubIndex 001 If this object is set to “0x64616F6C” in the set value dia-
log, all backup objects are reset to their delivery state.
UINT32 RW 0x00000000 (0
dec
)
6.2.2 Configuration data
Index 80n0 AI Settings for 0 ≤ n ≤ 4 (Ch. 1 - 5, dependent on the number of channels)
The filter characteristics are set via index 0x8000:15 [
}
36]
The filter frequencies are set for all channels of the module centrally via index 0x8000:15 (channel
1). All other corresponding indices 0x80n0:15 have no parameterization function! The latest
firmware version (see
status table [
}
46] ) returns an EtherCAT-compliant error message, if the filter
characteristics of other channels (index 0x80n0:06, 0x80n0:15) are set.
Index
(hex) Name Meaning Data type Flags Default
80n0:0 AI Settings Maximum subindex UINT8 RO 0x1C (28
dec
)
80n0:01 Enable user scale Enablement of the user scaling BOOLEAN RW 0x00 (0
dec
)
80n0:05 Siemens bits The S5 bits are shown in the three low-order bits (value
0x60n0:11 [ } 37] )
Bit 0 = 1 (“overrange” or “underrange”)
Bit 1 (not used)
Bit 2 (not used)
BOOLEAN RW 0x00 (0
dec
)
80n0:06 Enable filter Enable filter, which makes PLC-cycle-synchronous data
exchange unnecessary BOOLEAN RW 0x00 (0
dec
)
80n0:07 Enable limit 1 The status bits are set in relation to Limit 1 BOOLEAN RW 0x00 (0
dec
)
80n0:08 Enable limit 2 The status bits are set in relation to Limit 2 BOOLEAN RW 0x00 (0
dec
)
80n0:0A Enable user calibration Enabling of the user calibration BOOLEAN RW 0x00 (0
dec
)
80n0:0B Enable vendor calibra-
tion Enabling of the vendor calibration BOOLEAN RW 0x01 (1
dec
)
80n0:0E Swap limit bits Swap limit bits BOOLEAN RW 0x01 (1
dec
)
80n0:11 User scale offset User scaling offset INT16 RW 0x0000 (0
dec
)
80n0:12 User scale gain This is the user scaling gain.
The gain is represented in fixed-point format, with the
factor 2
-16
.
The value 1 corresponds to 65535 (0x00010000).
INT32 RW 0x00010000
(65536
dec
)
80n0:13 Limit 1 First limit value for setting the status bits (resolution 0.1
°C) INT16 RW 0x0000 (0
dec
)
80n0:14 Limit 2 Second limit value for setting the status bits (resolution
0.1 °C) INT16 RW 0x0000 (0
dec
)