Decommissioning
CX51x0
81
Version: 2.8
11
Decommissioning
11.1
Removing cables
NOTE
Electrical voltage
If the power supply is switched on during dismounting, this can lead to damage to the Embedded PCs.
Switch off the power supply for the Embedded PCs during dismounting.
Before dismantling the Embedded PC, shut down the Embedded PC and switch off the power supply. Only
then can you remove all the cables. Also remove all cables from the first terminal after the power supply
terminal.
Requirements:
• Terminate your software and shut down the Embedded PC.
• Switch off the power supply.
Remove the cables as follows:
1. Remove the cabling from the Embedded PC.
2. Remove the wiring from the first terminal next to the power supply terminal.
3. Pull the orange strap to remove the first terminal after the power supply terminal by pulling it forward.
ð
In the next step the Embedded PC can be removed from the DIN rail and dismantled.
11.2
Dismantling the Embedded PC
This chapter explains how to dismantle the Embedded PC and remove it from the mounting rail.
Requirements:
Summary of Contents for CX51 0 Series
Page 1: ...Manual EN CX51x0 Embedded PC 9 10 2021 Version 2 8...
Page 2: ......
Page 85: ...Technical data CX51x0 85 Version 2 8 2 Transport and storage 11...
Page 92: ......
