Decommissioning
CX2550-0179 / CX2550-0279
28
Version: 1.0
After pulling on the terminal release of the power supply unit (see arrow) the block can be
carefully
removed
from the DIN rail.
Disposal
The device must be fully dismantled in order to dispose of it.
Electronic parts must be disposed of in accordance with national electronics scrap regulations.
3. Disconnecting the system interface
Disconnecting the system modules from the basic module
If the modules are locked, i.e. attached with tie clips, the clips must be released. To this end lift the tie clips
with a screwdriver and pull them out. Subsequently, the system interfaces can be separated again.
Attention
Do not use force to open the device!
Opening the module housing by force would destroy it. The devices may only be opened by
Beckhoff service personnel.
