Foreword
Operator’s obligation to exercise diligence
The operator must ensure that
•
the Industrial PC is only used for its intended purpose (see chapter
•
the Industrial PC is only operated in a sound condition and in
working order (see chapter
•
the Industrial PC is operated, maintained and repaired only by
suitably qualified and authorized personnel.
•
the personnel is instructed regularly about relevant occupational
safety and environmental protection aspects, and is familiar with
the operating manual and in particular the safety notes contained
herein.
•
the instruction manual is in good condition and complete, and
always available for reference at the place of installation of the
Industrial PC.
•
none of the safety and warning notes attached to the Industrial PC
are removed, and all notes remain legible.
•
every user is familiar with all the functions of the software installed
on the Industrial PC to which he has access.
National regulations
depending on the machine
type
Depending on the type of machine and plant in which the Industrial PC is
used, national regulations governing the controllers of such machines will
apply, and must be observed by the operator. These regulations cover,
amongst other things, the intervals between inspections of the controller.
The operator must initiate such inspections in good time.
Do not open the housing of the build-in Panel PC
Note
For technical support contact
Procedure in the event of a
fault
In the event of faults at the Industrial PC, the list in the section
can be used to determine the measures to be taken.
Operator requirements
Read the operating
instructions
Anyone who uses the Industrial PC must have read these operating
instructions.
Software knowledge
Every user must be familiar with all the functions of the software installed
on the Industrial PC to which he has access.
6
CP62xx
