Becker L120/11C PSF, Assembly And Operating Instructions Manual, Page: 16 / 24

Deleting the desired intermediate position
Open/close the shading solution to the desired intermediate position.
Press the STOP button and, within 3 seconds, also press the travel button assigned to
the intermediate position and hold the two buttons down.
▻ The tubular drive makes a clicking sound to confirm.
► The intermediate position is now deleted.
Programming additional transmitters
In addition to the master transmitter, up to 15 further transmitters can be programmed in
the tubular drive. Before programming a radio controlled Sun-Wind-Sensor, the limit posi-
tions must be programmed.
Press the programming button of the master transmitter for 3 seconds.
▻
The tubular drive makes a “click” sound to confirm.
Now press the programming button of a new transmitter which has not yet been pro-
grammed in the tubular drive for 3 seconds. Doing so activates the programming
mode of the tubular drive for a new transmitter for 3 minutes.
▻ The tubular drive makes a “click” sound to confirm.
Now re-press the programming button of the new transmitter you wish to programme
for 3 seconds.
▻ The tubular drive makes a clicking sound to confirm.
► The new transmitter is now programmed in.
Deleting transmitters
Deleting individual transmitters
The programmed master transmitter cannot be deleted. It can only be overwritten (see
Programming the master transmitter [
}
12] ).
Press the programming button on the master transmitter for 3 seconds.
▻ The tubular drive makes a “click” sound to confirm.
Now press the programming button of the transmitter to be deleted for 3 seconds.
▻
The tubular drive makes a “click” sound to confirm.
Then re-press the programming button of the transmitter to be deleted for 10
seconds.
▻ The tubular drive makes a clicking sound to confirm.
► The transmitter is now deleted from the tubular drive.
16