Installation
Install the control unit so that the control elements are easily accessible.
Caution
•
Before installation, the control unit must be checked for any damage sustained in trans-
port or elsewhere. Damage to the interior of the control unit may lead to considerable
consequential damage to the control unit and jeopardise the safety of the operator.
•
Touching electronic components, particularly parts of the processor circuit, is forbid-
den. Electronic components may be damaged or ruined by electrostatic discharge.
•
Before opening the housing cover, you must ensure that any drilling chips or shavings ly-
ing on the cover do not fall into the housing.
•
You must ensure that the control unit is installed distortion-free.
•
Any unused cable entries must be closed off by appropriate means in order to maintain
the degree of protection of the housing.
•
The cable entries must not be exposed to any mechanical loads, particularly tensile
loads.
•
The CEE plug (if any) must be highly visible and accessible from the control unit.
Attaching the fastening brackets
1.
2.
4x
Removing the fastening brackets
4x
3.
1.
2.
7
