General
This door control unit is a high-quality product with the following performance characteristics:
•
The control unit is available in the following versions:
∙
R – relay control unit
∙
S – contactor control unit
•
Positioning the door at and between its limit positions (open, close and intermediate positions)
•
Evaluation of safety sensors on the door (e.g. closing edge surveillance, pull-in safety device and similar)
•
Evaluation of additional safety devices on the door (e.g. light barrier, light grids and similar)
•
Evaluation of control sensors on the door (e.g. pull switch, radio, induction loop and similar)
•
Evaluation of EMERGENCY STOP control sensors
•
Supplying sensors and control sensors with fused 24 V safety extra-low voltage
•
Supplying external devices with 230 V
•
Operation of application-specific outputs (e.g. relay for door position messages)
•
Generation and output of diagnostic messages
•
Setting application-specific parameters in various access levels for different groups of users
•
Operation of input/output extension modules
•
Plug-in module for radio remote control unit
•
Plug-in module for safety radio system
You will find the current status on the type plate according to the following symbol:
Please observe these Assembly and Operating Instructions when installing and setting up the equipment.
Explanation of pictograms
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could
result in injury.
ATTENTION
ATTENTION indicates measures that must be taken to avoid damage to
property.
Denotes user tips and other useful information.
Warranty
Structural modifications and incorrect installation which are not in accordance with these and our other instructions can result in
serious injuries, e.g., crushing of limbs. Therefore, structural modifications may only be carried out with our prior approval and
strictly in accordance with our instructions, particularly the information contained in these Assembly and Operating Instructions.
Any further processing of the products which does not comply with their intended use is not permitted.
The end product manufacturer and fitter have to ensure that all the relevant current statutory, official and, in particular, EMC regu-
lations are adhered to during utilisation of our products, especially with regard to end product manufacture, installation and cus-
tomer advice.
3
