Becker Avionics
DV16401.03 Issue 04 May 2021
BD406/PBD406
85
Audio Notification
BD406 without control head:
N/A.
•
BD406/PBD406 can supply voice notifications to speaker or headphones. Audio
messages are supplied on demand or in case of special event which occurs in the system.
•
The operator is notified about device malfunctions or when signal from distress beacon is
detected.
Spoken Phrase Description
Zero
Message supplied when digit 0 is reported.
One
Message supplied when digit 1 is reported.
Two
Message supplied when digit 2 is reported.
Three
Message supplied when digit 3 is reported.
Four
Message supplied when digit 4 is reported.
Five
Message supplied when digit 5 is reported.
Six
Message supplied when digit 6 is reported.
Seven
Message supplied when digit 7 is reported.
Eight
Message supplied when digit 8 is reported.
Nine
Message supplied when digit 9 is reported.
Dot
Message supplied when the dot separator is reported.
Beacon
Message supplied when signal from beacon, which is already registered in
internal memory, is received.
New Beacon
Message supplied when signal from beacon, which is not registered in internal
memory, is received.
Degrees
Message supplied when the degree value is reported.
Distance
Message supplied when the distance to the target is reported.
Kilometers
Message supplied when the kilometer value is reported.
Miles
Message supplied when the nautical mile value is reported.
Beacon Decoder
Failure
Message supplied when error is found during PBIT.
True Bearing
Message supplied when true bearing is necessary.
Unknown
Message supplied when reported value is unknown.
Message called homing. It contains phrase:
"True bearing: XXX degrees. Distance XXX.X kilometers (miles)."
Example of a spoken message:
"True bearing: Two, three, five degrees. Distance: One eight nine dot four
kilometers."
•
When distance is set to nautical miles word kilometers is replaced with miles.
•
When distance/true bearing are not valid the device announces:
o
"True Bearing: Unknown. Distance: Unknown."
o
Homing message is triggered by push rotary knob (depends on
configuration).
