Beck GmbH & Co. Elektronik
Bauelemente KG
Eltersdorfer Str. 7
90425 Nürnberg
Germany
Tel.: +49
– (0)911 – 9 34 08 – 0
Fax: +49
– (0)911 – 9 34 08 – 28
E-Mail: [email protected]
Internet: www.beck-elektronik.de
Preliminary
Product Specification
EPD Driver Board
Page 5 of 12
All EPD connectors are lock types. Please be sure that before display’s
connection the lock is open. When connecting the display to the connector on
the EPD driver board, make sure that the contacts on the display's cable are
located at the bottom side. See figure below.
After connecting the display, fix the cable with the lock, pressing it down.
Display Voltige Settings
To install the EPD gate supply voltages, the micro switch block SW1 is used.
The necessary parameters for EPD gate supply voltages can be found in the
characteristics of the display. Using Table 1, set the Gate negative supply and
Gate Positive supply voltage by SW1 according to the display documentation.
Figure 2: SW1 Jumpers for gate voltage setup
