Hole
for fastening screws
(screws not included)
Hole for
fastening
screws
S
haft
for
dial knob
Control
Light
Sockets
0
dial knob
Shaft
Extension
DIRECTIONS:
1.
Remove packaging and carefully pull off the DIAL KNOB ONLY while holding on to the round plate. Do not use force or tools!
2.
Now separate the round steel plate from Control Light Sockets by carefully wiggling it away WITH the yellow and green light plastic caps
Hold one with two fingers and gently pull plate away; repeat with other. Yellow and green PLASTIC CAPS STAY IN PLACE in the plate.)
3.
Mark all necessary holes utilizing the provided template below. Drill required holes and gently thread light sockets through their
designated openings. DO NOT SNAP THE PRONGS! Now fasten the box to interior of cabinet wall or underside of counter top.
4.
Gently pull light sockets out a little bit and re-connect with plastic caps in the metal plate; affix plate with two small flathead screws, or
silicone into place.
CAUTION: DO NOT TWIST OR SNAP DELICATE WHITE WIRING OF INDICATOR LIGHTS.
5.
Connect the hollow extension to s
haft
if needed (packed with nuts + washers). Slide dial knob onto stem (match flat side of stem
with flat side of female receptacle at back of knob). Do not use force.
BUILT-IN TEPPAN
TYPE “B” CONTROL BOX
CONCEALED MOUNT
4”
(102
mm)
3”
(76 mm)
(60
2
m
-3/8”
m)
5-3/8”
(137
mm)
Hol
es
to attach
metal
cover plate (screws
not included)
Hole
for
s
haft
Control/Indicator Light
Plastic Caps
1
1/16"
1
1/16"
9/32"
9/32"
1 17/32"
1 17/32"
1 13/16 in
4 7/8"
ø
3/8”
10 mm
ø
5/8”
16 mm
CAUTION: DO NOT SNAP, PULL or TWIST THE CONDUIT DURING INSTALLATION ! ! !
Warranty will expire if capillary tube inside the conduit is damaged during installation.
Control box must be firmly fastened to a non-moving surface.
VERY IMPORTANT: Do not open the control box or warranty expires
!
! !
Stainless
Steel
Cover
Plate
3-1/8“ dia (80 mm)
exterior
cabinet wall
interior
cab inet
YELLOW
GREEN
7 mm
39 mm
18 mm
18 mm
46 mm
39 mm
7 mm
124 mm
5 3/8"
137 mm - PLEASE MEASURE ACROSS TO MAKE SURE TEMPLATE IS 1:1
Prongs prevent
light sockets from
slipping
back
into box
IMPORTANT: To use as 1:1 template set “page scaling” to “none” when printing
©2020 p&p |
www.cookndine.com | All rights, errors and misprints reserved.
---
---
drill
drill
position for fastening
screw; DO NOT
DRILL THROUGH!
position for fastening
screw; DO NOT
DRILL THROUGH!
DO NOT OPEN BOX
NOR REMOVE
THIS SCREW!
!!! PLEASE USE THE PROVIDED METAL TEMPLATE ONLY !!!