April, 2017, V 1.1
3
Installation Guide E700M & E800A Workstations
SECTION 1
TOOLS REQUIRED
Phillips Screw Driver for all Screws on the unit
Flat Screw Driver or Snips for removal of Staples
Teflon Tape
Adjustable Wrench
PARTS REQUIRED
Hose and Fittings for connection to Regulator
Compressed Air Line next to unit
UNPACKAGING THE UNITS
Step 1
: Carefully inspect the shipping carton
for any signs of transport damage.
Step 2
: Begin by removing the staples
attaching the box to the skid (A Flat Screw
Driver or Snips will do the job).
Carefully remove your Spray Gun Washer
from the shipping carton.
Remove the four screws from the bottom of
the Spray Gun Cleaner connected to the
palette
Remove the unit from the palette and place it
in the general area for installation.
You are ready to begin with the installation of
the Spray Gun Cleaner.
Warning!
Do not use electrical or
spark producing equipment in existing Paint
Mix Rooms until all potential Hazards and
(vapors, material spills etc) have been
removed
Note: Workstation shown w/ optional Cover Door
