background image

 

Jul 2011, V 1.0 

7

 

       Installation Guide E100M 

 

       

 

          

BECCA HEATER SYSTEMS 

(Optional) 

“Heater5” General Purpose Heater (outside mix room) 

“HeaterEXP” Cls I Div 1- Heat on Demand (Inside or outside of mix room 

                

Instructions for set-up and use 

 

™

 

Fill with 5 gal. Distilled Water and one bottle of BECCA WaterWave Additive (well 
shaken) - - OR - - 5 gal of Paint Co. supplied Waterborne Paint Gun Cleaning 
Solution & one bottle of BECCA WaterWave Additive (well shaken) 
 

™

 

Program 7 day timer (supplied by BECCA): 
 

1.  For Heater5 -  turn “ON” 2 hours before shop opens - - and turn “OFF” at 

typical shop closing time. (Monday thru Friday or Monday thru Saturday) 

2.  For HeaterEXP - turn when shop opens - - and turn “OFF” at typical shop 

closing time. (Monday thru Friday or Monday thru Saturday) 

 

™

 

Plug in timer to electrical outlet - - plug in heater to timer 

1.  Note: When HeaterEXP is located in Mix room the connection can be any 

of the following: 

1.  Exp Cable supplied can be run through the wall and connected 

outside the mix room 

2.  Exp cable minus the plug can be connected inside the mix room to 

an Exp switch or timer (neither are supplied) 

 
 

Warning! 

 

ƒ

 

Evaporation will reduce fluid level - - Check fluid daily and replace as needed. 
DO NOT ALLOW FLUID LEVEL TO DROP BELOW HALF-FULL! 
 

ƒ

 

The purpose of the BECCA nylon pail liners (part #823203-6) is to protect the 
metal container from rusting-out and leaking. DO NOT USE THE HEATER 
WITHOUT A PAIL LINER!

 

 
 
 

Summary of Contents for E100M









Reviews: