BEC Audio
1325 Millersport Hwy (Suite 203) Williamsville, NY 14221
Toll Free 888-556-3998 / Main Office #716-689-0871
·
Check for shorts or opens on intercom station cable runs.
· Check for shorts or opens on chime module and door station cable runs. (Continuous
chime will lock up the master. See System Diagnostics.)
·
Reset master unit by inserting a paperclip in the reset hole, which is located
behind the door.
·
Check that there are not a lot of excess room station cables run behind the
master. Bulky wire may cause master circuit boards to compress against each
other and trigger the buttons
.
·
Check
the total length of run isn't above 350' or system over 1000' total
If there is no radio or intercom audio:
·
Check that room switches are not in the “OFF” or “MONITOR” position.
·
Check that volume settings and controls are set properly. (See AUDIO
SETTINGS)
·
Make sure the “SOURCE” selection is correct.
·
Check for shorts or opens on intercom station cable runs.
·
Check that room station and patio connectors are terminated correctly.
·
Reset master unit by inserting a paperclip in the reset hole, which is located
behind the door.
·
Possible defective master.
If the unit has hum, popping, or audible oscillation:
·
Check that room station and patio connectors are terminated correctly.
(Remove room stations from the master one at a time to identify the source of
the interference.)
·
Check for shorts on intercom station cable runs.
·
Check that cable runs are not too close to AC lines.
·
Check that room stations and master are not mounted too close to electrical
equipment. (i.e. TV, Cordless phones, microwave oven, etc.)
