bebob factory GmbH – Höglwörtherstr. 350 – D-81379 München – Tel.: +49 89 27818282
April 2016
Battery Swap
•
The ML-120V/V-HL detects a battery as empty when the voltage drops below 12,5V
•
The ML-120V/V-HL instantly takes over powering the Camera and the D-Tap port for a
maximum of 2 minutes and displays a red LED alarm
•
The LED Alarm flashes for 90s, turns to solid for the last 30s.
•
After the empty battery has been replaced by a charged one (voltage under load of over
14,5V), powering of the Camera instantly reverts to the V-Mount battery.
•
The ML-120V/V-HL switches up to 6 Times before running empty
•
If the empty battery is not replaced within 2 minutes the ML-120V/V-HL and the Camera
will switch off.
Alarm LED´s brightness
•
To allow the Alarm LED to be visible in bright environments (sunlight etc.) but not
disturbingly over bright in darker environments (studio etc.), the ML-120 has automatic
brightness adjust.
•
The brighter the environment the brighter the alarm LED will show.
•
The environment light detector is located at the top – middle of the ML-120 housing.
•
Covering the housing (with tape for instance) will switch off the automatic brightness adjust
and the alarm LED will flash with minimum brightness
Safety instructions
•
Only for professional use! Keep Charger out of reach of children and personnel that has
not been instructed in the use!
•
Use only with recommended batteries.
•
Keep the ML-120V/V-HL dry and do not immerse in water.
•
Do not attempt to open or repair the ML-120V7V. Contact your dealer for help if it becomes
defective.
•
Handle with care! Do not throw! Do not drop!
Warranty
•
The ML-120V/V-HL is covered by a 2 years unconditional warranty on all parts, except the
cells.
•
The cells are covered by a 2 year warranty, 80% of the original capacity.
•
For warranty issues or if you have any additional questions, please contact the appropriate
bebob distributor listed at
