GB
READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE
YOUR CHILD’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE
INSTRUCTIONS
WARNING:
This seat has been designed to be operated as shown in the instructions
supplied. Not to do so may cause damage and render your guarantee void.
1- FOOTREST:
The footrest can be adjusted to 2 positions.
To lower it pull the swinging support (D) forward and to lift it push the swinging support
(D) backwards.
2- ADJUSTING BACKREST:
The backrest can be adjusted to 4 positions. Pull up the
handle (C) situated behind the seat and simultaneously move it to the desired position.
NB.
Always fasten the press-studs of hood, when using the seat in the horizontal
position.
3- HARNESS RESTRAINT:
Shoulder adjustment is made by pulling the straps through the
adjusters indicated until a snug fit is obtained. Remember the amount of clothing your
child is wearing will affect the fit so check the adjustment each time the pushchair is
used.
NB.
“D” rings are located near the bottom of the backrest on the seat, and underneath
the carrycot mattress for the use of an additional harness complying with BS6684.
4- MAIN BUCKLE OPERATION (OPENING):
Press simultaneously the two red buttons on
the buckle, until both clips separated from it.
5- MAIN BUCKLE OPERATION (CLOSING):
Join the two clips together, and then fit it into
the main buckle, until it clicks firmly into position (check security by gently pulling in
opposite direction).
6- BUMPER BAR:
To remove the bumper bar press the buttons on the armrest.
To fit, insert ends into armrests.
7-
To fit the hood, insert bayonet fitting into slots in armrests.
To remove, press the buttons on the armrest.
8- REMOVAL OF SEAT COVERS TO WASH:
Unfasten the press-studs on seat and on
the armrests.
Pull of cover on side panels. Lift cover from the backrest.
Note:
To fit the seat fabric follow the steps in the reverse order.
IMPORTANT
- Before washing, refer to the separate washing instructions included with
this pushchair.
9- TO FIT SEAT:
Seat may be forward or rear facing. Place seat runners in attachment
points (B) on both sides. Lower into position (A) and lock will automatically engage.
Ensure seat frame runners are secure at all 4 attachment points (A & B on both sides).
Summary of Contents for Folding Seat ST
Page 2: ......
Page 4: ...1 2 4 5 1 2 D D 1 2 3 4 C 3 ...
Page 5: ...6 7 8 ...
Page 7: ...10 A D 2 4 C E 1 G G A B A D B B C F F G G D A F B B F 5 A D D B 3 ...