8 Operation Procedures
8.1 Adding Water
•
Before first use, please read the Instruction Manual carefully.
•
Place the appliance on a level flat surface.
•
Ensure the power plug is disconnected from the power point.
•
Open the lid and fill to the “Max” mark with clean cold tap water.
•
Place the item to be cleaned into the tank.
•
Ensure the water does not rise above the “Max” mark. If it does, remove some of the
water then close the lid
Note
: Do not overfill the tank.
Do Not use the cleaner without water as this will damage the appliance.
8.2 Enhanced Cleaning
•
If your articles are very dirty or smeared, add approximately 10 – 15ml of dishwashing
liquid to the water and mix in well. This will help dissolve the dirt an degrease whilst
cleaning.
•
In some cases such as cleaning Silver articles, the use of a Silver Cleaning agent in the
water will be required as normal detergent will not work.
Important
: Ensure you follow the cleaning instructions supplied with the cleaning agent
carefully.
8.3 Switching On
•
Plug in to the Power Point and switch on. The Red Power Light will illuminate and the
default time setting will be displayed as 300 seconds.
Page 7 of 11
