13
Attaching the Whisk
1. Make sure the Hand Mixer is unplugged
and the speed control lever is set to
0
(OFF).
2. Align notches on the single whisk and insert
into the larger hole on the bottom of the motor
housing. Push until it clicks and locks
into place. (Figure 3)
CAUTION:
Always unplug the Hand Mixer before
attaching or ejecting the single whisk.
NOTE:
The collared whisk will fit and lock properly
into the larger hole ONLY. Do not try to force
it into the smaller hole. This could damage
the Hand Mixer.
CAUTION:
The whisk is designed to be used
on its own. When using the whisk, never use any
other beater or dough hook. This could damage
the Hand Mixer.
Operation
1. Be sure to unplug the power cord when the Hand Mixer is not in use.
Make sure the speed control lever is set to
0
(OFF).
2. Attach 2 beaters, 2 dough hooks or 1 single whisk following
the procedures previously described.
3. Plug the cord into a 120V AC electrical outlet.
4. Place beaters, dough hooks, or whisk directly into container holding
ingredients to be mixed.
5. Slide the speed control lever from Speed 1 to 6 to adjust speed to match
the mixing task. (See Beautiful Mixing Chart.)
6. Mix ingredients to desired consistency.
CAUTION:
When kneading yeast dough, set the speed to the lowest setting,
increase speed gradually until the highest speed is achieved.
Fig. 3
19109, 19110, 19111, 19112, 19131 BTFL Hand Mixer 6 Speed IM r8.indd 13
19109, 19110, 19111, 19112, 19131 BTFL Hand Mixer 6 Speed IM r8.indd 13
2022-01-05 12:21 PM
2022-01-05 12:21 PM
