Operating Instructions
Safety Instructions
Customer Service
Troubleshooting T
ips
12
Before you call for service…
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
WATER
Possible Causes
What To Do
Too many suds
Type of detergent
•
Switch to a lower sudsing detergent brand and follow
instructions on package.
Very soft water
•
Try less detergent.
Too much detergent
•
Measure your detergent carefully. Use less soap if you
have soft water, a smaller load, or a lightly soiled load.
Water leaks
Fill hoses or drain hose is
•
Make sure hose connections are tight at faucets and make
improperly connected
sure end of drain hose is correctly inserted in and secured
to drain facility.
Household drain may
•
Check household plumbing. You may need to call a
be clogged
plumber.
Constant water pressure
•
Tighten hoses at the faucets and turn the water off after
to the fill hoses at the
each use.
water source
•
Check condition of the fill hoses; they should be replaced
after 5 years.
Using too much detergent
•
Use less detergent. Use less soap if you have soft water,
in washer
a smaller load, or a lightly soiled load.
Water temperature
Control is not set properly
•
Check water temperature control (on some models)
is incorrect
or Cycle knob and adjust.
Water supply is turned off
•
Turn both hot and cold faucets fully on and make sure
or improperly connected
hoses are connected to correct faucets.
Water valve screens are
•
Turn off the water source and disconnect the water fill
stopped up
hoses from the upper back of the washer. Use a brush or
toothpick to clean the screens in the machine. Reconnect
the hoses and turn the water back on.
House water heater is
•
Make sure house water heater is delivering water
not set properly
at 120°F.–140°F.(48°C.–60°C.).
Water won’t drain
Drain hose is kinked or
•
Straighten drain hose and make sure washer is not
improperly connected
sitting on it.
•
Top of drain outlet should be less than 8 ft. (2.5 m)
above floor.
