SDR-6
Use of the transmitter:
Broadcast transmission: Connect the music source to the audio input and switch on
the transmitter. Make sure that the transmission channel matches the headphone
channel and then start the music signal.
Channel change: Press the “Change channel” switch to change the transmit channel
of the transmitter. The LED channel display will immediately show the change on the
display.
Charging: Connect the transmitter to the power supply via the power input socket. A
red light on the charge status display shows that the transmitter is being charged. A
green light indicates that the device is fully charged.
Microphone: Connect an external microphone via the microphone input socket.
Switch to microphone mode by pressing the corresponding switch. The microphone
indicator light will turn on to indicate that the microphone audio signals are now a
priority. Press the microphone switch again and the indicator light will go out. The
transmitter then returns to its previous state.
Bluetooth (Bluetooth frequency 2402-2480 MHz): Press and hold the Bluetooth
switch for 3 seconds while the device is switched on. The Bluetooth indicator light is
activated and the device is in Bluetooth mode. If the transmitter is switched on and
the Bluetooth mode is deactivated, the Bluetooth indicator light flashes blue
repeatedly. If the Bluetooth mode is activated, the indicator lights up permanently
blue. Press and hold the Bluetooth switch again for 3 seconds and the indicator light
turns red before it finally goes out. This indicates that the Bluetooth mode is
deactivated.
Bluetooth pairing: Press and hold the Bluetooth switch for 5 seconds while the
transmitter is switched on until the Bluetooth indicator light flashes alternately in red
and blue. The device is now in pairing mode. After a successful pairing, the indicator
light appears constantly in blue light. From now on, the audio signal of the paired
device is sent by the transmitter to the headphones.
Maintenance
Your device does not require any special maintenance. However, in the event of a
malfunction, contact an approved service center.
Cleaning
Use a lint-free and only slightly damp cloth for cleaning.
