V2021.01
Page 3
INSTRUCTION MANUAL
SEATPOST STRAIGHT & OFFSET
•
Under no circumstances you should use any force during
assembly if the seatpost can only be pushed into the seat tube
with great difficulty.
•
The usage of the supplied assembly paste reduces the
necessary torque.
•
The bolts on the seatpost clamp may only be mounted with
grease-free bolts. The maximum tightening torque of 5 Nm
must not be exceeded.
•
Abrasions of the carbon surface during assembly are
completely normal.
MOUNTING OF THE SADDLE
•
Attach the cross bolt. When doing so, the side with the
increment must face the rear and the smaller countersinks
must face upwards, as shown in the figure below.
•
Then place the lower clamping shell on the seatpost that the
relief heightening faces forward. An arrow (representing the
riding direction) is printed in the lower clamping shell and will
help you with the correct adjustment.
•
The upper clamping shell is mounted in the riding direction
with the slightly higher side facing forwards according to the
illustration below. An arrow (representing the riding direction)
is printed in the lower clamping shell and will help you with the
correct adjustment.
•
Afterwards, the longer screw (50mm) must be inserted at the
rear and the shorter screw (45mm) at the front.
•
Now place the saddle with its rails into the saddle support
grooves.
•
Set the desired saddle tilt by tightening the two screws
alternately. Never exceed the maximum permissible torque of
5 Nm.
•
Make sure that the clamping shells are aligned centrally in the
riding direction.
•
The saddle rail may only be clamped in the intended clamping
area.
•
If necessary, retighten the clamping screws to the maximum
specified torques after 1-2 hours of riding.
MAINTENANCE AND CARE
Always inspect your Beast Components product for integrity before
riding. Damage can lead to component failure, resulting in serious
injury or even death. Defective components should not be driven
on under any circumstances and should be replaced immediately. If
you are unsure, contact us or a specialist dealer.
The following issues should always be considered:
•
Regularly check the tight fit of all parts
•
When frequently adjusting the height of your seatpost in muddy
or dusty conditions, material wear actually takes place on the
surface of both the seat tube and seatpost. To keep this wear
to a minimum, we recommended removing the seatpost from
the frame after every ride in wet/muddy conditions and then to
clean it. The inside of the seat tube should also be cleaned with
a rag. Check the inside of your seatpost regularly for moisture
and remove if found.
•
Check the inside of your seatpost regularly for moisture and
remove if found.
Proper maintenance and care ensure a long service life and reliable
function.
DISPOSAL AND ENVIRONMENTAL PROTECTION
The statutory regulations shall apply. Whenever possible, avoid
creating waste. Waste, especially carbon, lubricants, cleaners and
any other fluids must be disposed in an environmentally compatible
manner.
CONTACT
Black East GmbH
Beast Components
Hermann-Mende-Str. 5-7
01099 Dresden, Germany
+49 351 501 937 00
[email protected]
www.beast-components.de
