V2021.01
Page 2
GENERAL INFORMATION
Our wheelsets are approved for tubular as well as tubeless systems.
Beast Components wheelsets are to be used exclusively with brake
discs. When used with rim brakes, they will be seriously damaged,
posing an enormous safety risk for the rider and third parties.
Modification of the wheelsets are not permitted and will void your
warranty.
WEIGHT LIMIT
Except for the RS25 and the XS30, our rims are not subject to any
weight limits. The system weight (bike, rider and equipment) of the
RS25 and the XS30 should be a maximum of 115kg and must not be
exceeded.
APPEARANCE
Our components are 100% handmade. Thereby it can come to
different appearances. It makes each component unique and has no
influence on the safety. By direct incidence of light you get a great
view of the individual fibers with partly shimmering shades.
WHEELSET ASSEMBLY INFORMATION
The choice of components as well as the spoking pattern and the
wheel construction itself influence the intended use of the entire
wheel and can significantly restrict it. Beast Components therefore
recommends to maintain the wheels by an experienced specialist.
This will ensure a long and problem-free service life.
If your wheelset should need maintenance or service, you or your
dealer will find information on the assembly of your wheelset in
this section and in the table on the following page. If there are any
questions, please contact us.
EFFECTIVE RIM DIAMETER (ERD)
The ERD is the direct distance between the opposite nipple seats.
The ERD tolerance is +1mm. Please refer to the table on the next
page for the exact ERD details of the respective rim.
ASYMMETRY OF THE RIMS
Please note the possible
asymmetry of the rim depending
on the rim model (see table on
next page). The asymmetrical
offset must point away from the
brake disc on the front wheel
and away from the gear shift on
the rear wheel to compensate
for the flange offset of the hubs.
NIPPLE
For optimal power transmission, we recommend to use as external
nipple „Sapim Polyax Double Square 14G 16mm“ with Secure Lock.
These must be positioned between the nipple and the rim and must
fit correctly on the inner surface of the rim.
WASHERS
When building up wheels with external nipples, it is essential to
use washers called „MG Washer“ from Newmen. These must be
positioned between the nipple and the rim and have to fit correctly
on the inner surface of the rim.
It is recommended to apply grease between nipple and washer to
prevent abrasion of nipple and washer.
SPOKE TENSION
The following maximum spoke tensions should neither be exceeded
nor undercut. Otherwise the spokes may break or the rim may be
damaged.
maximum allowable spoke tension of the higher
tensioned wheel side [N]
FW / RW 1200
TOLERANCES
The following maximum tolerances should not be exceeded or
undercut.
lateral
runout
[mm]
radial
runout
[mm]
concentricity
[mm]
ROAD
RS, RX, RR
± 0,2
± 0,2
± 0,2
GRAVEL GR,
± 0,25
± 0,2
± 0,2
MTB
XC, XS
± 0,25
± 0,2
± 0,2
TR, ED, DH
± 0,3
± 0,2
± 0,3
HY
± 0,4
± 0,2
± 0,3
ERD
INSTRUCTION MANUAL
WHEELSET