www.beast-tek.com
Pixel Drum Build Guide
Page 13
IO Board – Step 10
Carefully place a washer and nut on the PI and PIII pots. Also place two knurled jack nuts on the accent
and out jacks. Very gently tighten the nuts until they are “finger tight” DO NOT over tighten them as
they will twist the pots and jacks and/or pins will be bent.
Use a tube spanner or special tool like the awesome Rocket Sockets from Peppers Pedals to avoid
scratching and damaging the panel.
This should be enough to hold things together so that it can be flipped over to solder. Only solder one
pin of each jack and each pot to hold things in place.
