6
Using your BearCreeks BearCreeks
Navimate
Loading and dropping your bait
The left hand joystick operates the bait hopper door.
1
Insert your rig into a hopper, if desired, by passing it under the boat and up through the hopper.
2
Close the hopper door manually from below, ensuring ‘click’ closure.
3
Load the bait hopper with your chosen bait.
4
Navigate your boat to your chosen spot
5
Move the left hand joystick RIGHT to drop the bait hopper door. The blue hopper LED in the back
centre of the boat will flash 6 times to confirm the release of your bait.
Loading and releasing your rig
The left hand joystick operates the hook (rig) release system.
1
Insert your line, rig or hook on the hook release system pin situated on the back of the boat.
2
Push the left hand joystick LEFT to release the line, rig or hook. The white hook LED in the back
centre of the boat will flash 6 times to confirm the release of your hook.
How to locate the signal
1
Push both the left and right joystick to the middle and lower 45 degrees (see diagram) and turn on the
handset at the same time. The screen should now display “RX Binding”.
2
Turn the boat on.
3
Several seconds later, the screen will display “RX Bind OK” which means a signal has been found.
The blue signal lights are the rear of the boat will be on.
