Figure 3
(See page 2 for details)
ASSEMBLY & OPERATING INSTRUCTIONS FOR THE POWERBRUSH
When using the powerbrush, the basic precautions outlined under “IMPORTANT SAFETY
INSTRUCTIONS” should always be followed.
1. Push the wand into the powerbrush socket until it locks in place. The wand socket is designed with a
positive stop. Therefore, the wand will not jam in the wand socket. (figure 3)
2. Make sure the hose handle switch is in the OFF position.
Note: The handle is in the off position when the slide switch is
in the “O” position. (O I II)
3. Insert hose end into the powerbrush wand on the assembled powerbrush until is locks in place. (figure 4)
4. Insert the hose into the wall vacuum valve (faceplate), and plug the cord into the electrical outlet. (figure 5)
5. Lower the wand from the upright position.
6. Switch the powerbrush to the ON position. (“II”)
7. The wand can be telescoped by pushing the button closest to the powerbrush and pulling up.
8. To turn off the powerbrush, slide the switch to the OFF position. (“O”) Disconnect the handle from the wand by pushing
the button on the wand that is closest to the handle, and pulling the handle out of the wand socket.
9. Release the wand from the powerhead by depressing the foot pedal and pulling the wand out of the powerbrush socket.
Helpful Hint: To prevent possible damage to the Powerbrush, do not pick up hard or sharp objects. Articles of clothing, tow-
els, loose carpet edges, etc., should also be avoided. If an article does become entangled in the brush roller, switch off the
Powerbrush. Disconnect the hose cord from electrical outlet and the hose from the faceplate and then remove the object
carefully without using excessive force.
WARNING: Always switch off the Powerbrush and disconnect plug from wall electri-
cal outlet and disconnect hose before servicing the Powerbrush.
Figure 4
Figure 5
5
