VSM-200BEAM SHARPY
2
SAFETY INFORMATION
1) Installation
a. Make sure all parts for fixing the projector are in a good state of repair.
b. Make sure the point of anchorage is stable before positioning the projector.
c. The safety chain must be properly hooked onto the fitting and secured to the
framework, so that if the primary support system fails, the fitting falls as little as
possible.
d. If the safety chain gets used, it needs to be replaced with a genuine spare.
2) Minimum Distance of Illuminated Objects
a. The projector needs to be positioned so that the objects hit by the beam of light
are at least 12 meters from the lens of the projector.
3)
Mini
mum Distance from Flammable Materials
a. The projector must be positioned so that any flammable materials are at least
0.20 meters from every point on the surface of fitting.
4) Mounting Surfaces
a. It is permissible to mount the fitting on normally flammable surfaces.
5) Maximum Ambient Temperature
a. Do not operate the fixture if the ambient temperature (Ta) exceeds 40
℃
(104
℉
).
6) IP20 Protection Rating
a. The fitting is protected against penetration by solid bodies of over 12mm in
diameter, but not against dripping water, rain, splashes or jets of water.
7) Protection Against Electrical Shock
a. Connection must be made to a power supply system fitted with efficient earthing.
b. It is, moreover, recommended to protect the supply lines of the projectors from
indirect contact and/or shoring to earth by using appropriately sized residual
current devices.
8) Connection to Mains Supply
a. Connection to the electricity mains must be carried out by a qualified electrical
installer.
b. Check that the mains frequency and voltage correspond to those for which the
projector is designed as given on the electrical data label.
c. This label also gives the input power to which you need to refer to evaluate the
maximum number of fittings to connect to the electricity line, in order to avoid
overloading.
9) Temperature of the External Surface
a. The maximum temperature that can be reached on the external surface of the
fitting, in a thermally steady state, is 100
℃
(212
℉
).
10) Maintenance
a. Before starting any maintenance work or cleaning the projector, cut off power
from the mains supply.
b. After switching off, do not remove any parts of the fitting, to avoid getting burnt for
at least 35 minutes. After this time the likelihood of the lamp exploding is virtually
