12
Tracking / Alert Monitoring
IsatDock DRIVE has an in-built GPS module
that can provide tracking, monitoring and alert
management in various land and sea based
applications within various types of vehicles,
vessels or fixed site locations.
The GPS module provides accurate positioning
and enables tracking worldwide. The tracking
function has to be configured and enabled
on the IsatDock DRIVE via the Falcon. Once turned
ON, tracking and alert messages can be sent to a
phone number, e-mail address, LeoTrak-Online or
any other tracking application via SMS.
Tracking messages can be sent from the
IsatDock DRIVE in the following ways;
1. Periodic position reporting, which is preset
during configuration of the IsatDock DRIVE
2. A current location position can be sent at
any time by pressing the Track button on
the front of the IsatDock DRIVE
The Alert mode can be activated on the
IsatDock DRIVE in the following ways;
1. Use the two button press (know as the Alert
button) on the front of the cradle
2. Use an external alert button/emergency
push button connected to the alert loop
•
Firmware maintenance
•
Configure different POTS/RJ11 settings
NOTE
Entering the firmware upgrade mode will be
accompanied by a long beep followed by three
short beeps.
Configuration Using Remote
Commands
Configuration instructions or “Remote
Commands” can be sent to the terminal via
SMS, and most settings are supported that are
normally accessible from Falcon. Please refer to
the Falcon user manual for more information.
NOTE
Due to memory limitations it is recommended
that users have no more than 20 SMS messages
in their inbox. If this amount is exceeded the
processing of remote commands and the ability to
retrieve the messages via the Falcon tool may be
compromised.
Once activated, alert messages will be sent to
the preset destination continuously until the
alert is disabled either remotely or locally on the
IsatDock DRIVE unit.
LeoTRAK-Online Global
Tracking Portal
LeoTRAK-Online is Beam’s own global web based
alert monitoring and tracking application, which
enables you to track, trace and monitor your asset
anywhere on earth for a small monthly fee
through a simple-to-use web portal.
For more information about LeoTRAK-Online and
associated charges please visit:
www.leotrakonline.com
Configuration using Falcon
Falcon can be downloaded from:
http://www.beamcommunications.com/
support/drive
Follow the instructions in the downloaded
application to install. Once complete, connect
your PC to the USB port of the terminal and start
Falcon. You can then use the application for a
range of options such as:
•
View the status of the terminal (signal,
temperature, input voltage)
