Garage Vac Installation Instructions
Maintenance
1. Press fit the 45°bend and inlet flap into the tube exiting from the top
side of the appliance and tighten the retaining screw. Orientate to
preferred position, but so that the inlet flap is in the ideal position.
2. Connect the two spade connectors to the screws at the top of the inlet
flap and screw down tightly.
3. Position the appliance against the wall, marking the position of the
holes through the three foot-plates with a pencil. Ensure appliance is
close enough to a standard plug socket if an extension lead is not being
used.
4. Drill the three holes to accommodate the rawl plug and wall screws.
5. Screw the appliance to the wall and plug the vacuum hose in.
6. When the hose is inserted into the inlet, the appliance should
automatically turn on and when the hose is withdrawn it will switch off .
To empty the bag, release the two spring-clips from the side of the lid to
reveal the bag compartment. Remove and dispose of the bag when full,
press the replacement bag firmly over the intake pipe and secure the
lid.
Replacement bags are available in packs of three from our sales
department, re-order code: 6007.
Garage Vac Installation Instructions, Issue 2, 24.03.10, T.H.E Ltd, E&OE.
If you require any help with the installation of the Garage Vac
system in your home, please contact Beam Central Vacuums on
0845 260 0123
Our service department will be happy to help 9am-5.30pm Monday to Friday.
