18
Stealth Mode
For special applications the handset LED can be temporarily
disabled. This is achieved by holding down the VOLUME UP/
DOWN (both) while powering up the unit. To turn the LED
back on, simply power down and power back up.
Additional Headsets
The 6 pin industrial connector at the bottom of the wireless
handset also allows the use of a variety of heavy duty
and lightweight headsets and application specific audio
accessories to enhance your communications capability.
Use either the headset/accessory’s integral PTT or use
the wireless handset to transmit. The internal speaker is
immediately disabled when a headset is plugged in.
N.B. See page 7 for safety warning regarding use of headsets.
Accessory Mic Boost
Users can increase an audio accessory’s microphone gain
on the handset models fitted with the Hirose accessory
port to cater for sensitivity requirements or variations
in headset manufacturer’s specifications. To activate the
higher sensitivity, the Wireless Handset’s blue VOLUME UP
button should be held down while powering up. The user
will thereafter hear 2 short confirmation beeps at the end of
each start up tone sequence. To revert to normal sensitivity,
the unit should be powered up with the VOLUME DOWN
blue button held down.
NOTE:
This does NOT affect the sensitivity of the handsets
normal internal front cover microphone.
Dock Loudspeaker Operation
(Corded and Wireless Handset)
The BEAM DriveDOCK Extreme includes the standard
loudspeaker (as used in normal Phone hands-free calling). This
loudspeaker can also be configured to provide audio in PTT
operation. This provides an extra output in addition to the
handset.
To use the DriveDOCK Extreme loudspeaker with the handset:
1.
Press/hold the Dock Ringer button for 2 seconds. This
will change to the DriveDOCK Extreme loudspeaker
mode, and will be signified by playing the triple rising
tone in the DriveDOCK Extreme speaker and PTT speaker.
Also the Ringer LED will flash GREEN 3 times.
2.
Audio is now set to output on both the DriveDOCK
Extreme speaker and the handset.
To revert to using the handset speaker only:
1.
Press/hold the Dock Ringer button for 2 seconds. This
will change to the handset speaker mode, and will be
signified by playing the triple rising tone in the Wireless
Handset speaker (not the DriveDOCK Extreme speaker).
Also the Ringer LED will flash GREEN 3 times.
2.
Audio is now set to be silent to the DriveDOCK Extreme
loudspeaker. The audio output setting is saved even
when the dock is switched off.