S242P User Manual
8
l
QUICKLY STARTING
Note:
Be sure that the power switches of both the computer and the monitor are OFF.
l
CONNECTING THE CABLES
Put the signal cable into the back of the monitor connector, then plug the other end into the
computer's display interface.
As shown in the figure below.
After connecting, tighten the screws.
l
STARTING UP
Put the power cord into the back of the monitor power connector, then plug the other end into a power
outlet. Turn on the switch of the monitor, meanwhile, the power indicate LED will be light (blue
color).Then start the computer or the device.
Set the display mode as bellow: Resolution: 1920x1080, Refresh ratio: 60Hz.
If no image shown in the screen, please refer to the "failure analysis" to get help.
WARNING
Please use the enclosed power cord to connect the standard power outlet.
Please ensure that the monitor's power plug can be fully inserted into the socket. Make sure the power cord used
within the rated voltage. Or it may result in fire or electric shock.
Equipment must be connected to a outlet that grounded good.
Or it may result in fire or electric shock.
Please turn on the monitor and then computer power.
The monitor's power indicator will light (green). If the image does not appear, refer to the "failure analysis" for
help. After each use, turn off the computer and the monitor.
Note:
This monitor can run for a long time, but life will be reduced. Recommended 10-minute break every hour.
Summary of Contents for S242P
Page 1: ...S242P User Manual 1...