2
INSTALLATION INSTRUCTIONS
FOR LIFT & TILT SCISSOR TABLE
STEP 1
- Unpack accordion skirt kit carefully. Avoid bending
the aluminum extrusions and rods.
STEP 2
- Refer to
Figure 1
at the right. Install steel angles
(
1
) on sides of deck frame using the predrilled holes (
2
) and
the self tapping screws (
3
) provided.
STEP 3
- Refer to
Figure 2
at the right. Thread the rope top
of the accordion skirt (
4
) into the aluminum extrusions (
5
)
taking care to match lengths. Identify the two longer sides of
the accordion skirt by the amount of exposure at each end of
the aluminum extrusions.
STEP 4
- Place the accordion skirt with extrusions installed
around the unit as shown in
Figure 3
. The skirt will rest on
the previously installed angles.
STEP 5
- Attach aluminum extrusions to sides of Lift Table.
Carefully line up holes in aluminum extrusion with holes in
side of Lift Table. Secure extrusion to table using 5/16" self-
tapping screws.
STEP 6
- Insert stiffener rods into accordion skirt. Locate ¼"
holes in ends of
BLACK convolutions of accordion skirt.
Carefully insert stiffener rod into hole, taking care not to rip or
damage the skirt.
INSTALLATION INSTRUCTIONS
FOR GROUND SCISSOR LIFT
STEP 1
- Unpack accordion skirt kit carefully. Avoid bending
the aluminum extrusions and rods.
STEP 2
- Refer to
Figure 1
at the right. Attach steel angle
back support (
4
) to the Lift Table using the 3/8"-16 x 1½" bolts,
3/8" flat washers and 3/8" lock nuts. Make sure steel angle
back support is attached to Lift Table before proceeding on to
the next step. NOTE: Steel angle back support should be
firmly attached -
DO NOT OVERTIGHTEN NUTS AND
BOLTS.
STEP 3
- Thread the rope top of the accordion skirt (
1
) into the
aluminum extrusions (
2
) taking care to match lengths.
STEP 4
- With the lift slightly elevated, place the accordion
skirt with extrusions installed around the unit as shown in
Figure 1
.
STEP 5
- Attach aluminum extrusions to sides of Lift Table.
Carefully line up holes in aluminum extrusion with holes in side
of Lift Table. Secure extrusion to table using 5/16" self-
tapping screws (
3
).
STEP 6
- Insert stiffener rods into accordion skirt. Locate ¼"
holes in ends of
BLACK convolutions of accordion skirt.
Carefully insert stiffener rod into hole, taking care not to rip or
damage the skirt.
FIGURE 1
(
1
) Accordion skirt with rope top
(
2
) Aluminum extrusion
(
3
) 5/16 x ½" self-tapping screw
(
4
) Steel angle back support
(
5
) Holes for mounting steel angle
1
3
2
5
4
FIGURE 1
FIGURE 3
FIGURE 2
5
4
1
2
3
