LAMPING – Integrated LED Module
1.
Make sure the power to the fixture is off.
2.
With the fixture still attached, remove the Cap or Cover from the Ground Spike, Junction
Box, or BSB.
3.
Disconnect the fixture leads from the supply wires.
4.
Loosen the three set screws at the bottom of the Lamp Housing with a 3/32” hex wrench
and slide it straight up to remove, exposing the LED Module.
5.
If the fixture is equipped with a Lower Shaft, loosen the three set screws at its bottom
with a 3/32” hex wrench and slide it up off the Base, pulling the wires up through the red
silicone plug inside the Base. (Figure 1)
6. Unscrew the LED Module 4-5 revolutions to remove it.
7.
Carefully press the red silicone plug out the bottom of the Base from the top with a
narrow, blunt object and save to be reinserted later.
8.
Feed the lead wires from the new LED Module through the Base (or Union and Lower
Shaft, if equipped, then the Base) and screw the Module down until it bottoms out.
9.
Replace the Lamp Housing (and Lower Shaft, if equipped) and alternately tighten the
set screws.
10.
Feed the leads through the silicone plug. Carefully slide the plug up the wires and
reinsert the plug back into the Base.
11.
Follow the final three Steps in the appropriate “Installation” section of these instructions
to complete the operation.
This fixture has a long-life LED Module that should not need replacement for years. However,
if a Module fails or technology improves and a new one is desired, replacements are available
from Beachside Lighting (808-263-5717). Once received:
LAMPING – MR16
1.
Make sure the power to the fixture is off.
2.
To access the lamp compartment, loosen the three set screws at the bottom of the Lamp
Housing with a 3/32” hex wrench and slide it straight up to remove, exposing the Lamp.
(Figure 1)
3.
Grasp the Lamp at its base and pull straight up to remove from socket.
4.
Holding the new Lamp at its base, align its pins with the holes in the socket and push
straight down.
5.
Reinstall the Lamp Housing. Apply a grease appropriate for use on silicone o-rings to
the o-rings if necessary.
6. Alternately tighten all three set screws.
